You currently have 0 items in your cart. Checkout Now.
CreateIdeasFAQPricesInstallAboutContact Us

    Installation Instructions For Your HuntHedz

  1. Select an area that is large enough to install your HuntHedz. The surface must be flat and clean. your HuntHedz must be at room temperature prior to installation. Remove the Hunthedz from shipping container and unroll. Lay flat on floor. Let stand at room temperature for 45 minutes to 1 hour.
  2. Clean the area that you selected, using water only, to ensure no residue will adhere to the Photo-Tex backing of your Hunthedz. USE WATER ONLY. Dry the surface thoroughly with a clean cloth or towel and let stand for approximately 45 minutes to ensure the area is completely free from any water residue.
  3. Its a lot easier if you use 2 people to install your Hunthedz. (depending on the size)
  4. Once your surface area is prepared simply peel the HuntHedz from the white paper backing. Start from the top or side of the HuntHedz and peel off the white backing.
  5. Once your HuntHedz has been completely taken off from the backing, each person grab the top corners of the HuntHedz.. Place the HuntHedz to the area you have selected to display it and press these corners to the wall. Don’t worry about any air bubbles, these can be worked out after install.
  6. Beginning from center of HuntHedz and using your hand, apply pressure and rub from center to outer edges to apply.
  7. Roll and store white paper backing in the shipping tube for future use if you decide to take your Hunthedz off the wall in the event you decide to remove and store your HuntHedz.
  8. If you decide to take your HuntHedz down pull off from one corner being very careful. Roll out white backing and re-stick your HuntHedz to it for storage or repeat step 1-7 and stick somewhere else.
  9. Enjoy Your new HuntHedz!